Tundra Remote Door Lock Reprogram

Repeat steps a and b in step 6 for each new remote.

Tundra remote door lock reprogram.

While there is the possibility of a pretty big electrical issue most of the problems are minor and easy to fix. The locks should cycle once to verify that the car has accepted your remote. Press the lock button by itself and hold for 2 seconds. Press and hold lock and unlock button for 1 5 seconds.

Insert your key into the ignition switch and put it in the run position. Press and release lock or unlock button. If not start again at step 1. Using the door control pad located on the driver s side door press the lock and unlock buttons once again for five passes.

Once your car is in programming mode with the remote you are trying to program press the unlock and lock buttons simultaneously for about 2 seconds then release and press just the lock button for 1 second. Luckily the toyota tundra power door locks are pretty easy to self diagnose what s wrong. If the door locks cycle twice repeat steps a and b in step 6 as the remote was not accepted. This is the best and easiest fix.

Close the driver s door. System should now lock and unlock vehicle once to confirm registration twice to indicate registration has failed. Repeat button procedure to program remaining remote transmitters. Remove your key from the ignition then wait for doors to lock and then unlock twice.

If you key fob no longer unlocks the doors it is time for a new battery. You must complete these operations within 40 seconds. If you have done everything correctly within three seconds the door locks should lock then unlock automatically.