Yet this application does make sense since concrete is heavy solid and is typically thought of as an unbending uncompromising material.
Tile over cement block.
If the paint comes loose so does the tile.
Once the cement is dry apply the bonding agent that should give the surface a rough texture.
The backerboard provided a smoother surface to tile on.
Clean the surface of any dirt or debris with a ph neutral cleanser and a sponge or scrub brush.
Construction board panels are extremely light and easy to cut but they provide a very strong durable and waterproof surface on which tiles will be installed.
For application over an uneven concrete surface a lightweight waterproof construction board must be used as an alternative to concrete board in a tile installation.
Answer it is possible to bond porcelain tile to a painted surface but it isn t recommended because the overall tile attachment is limited to the strength of the bond of the paint to the concrete.
They are screwed into the wall and are waterproof and thermally insulating.
First chip the bumps cracks and dents on the concrete wall with a hammer.
Kerdi board building panels can be used to create a ready made flat and plumb surface on the cinder block wall.
The easiest product to use on a cinder block wall is.
How to install ceramic tile over painted block walls for a shower.
Mix surface bonding cement with water to a pasty consistency.
Clean debris off the wall with water and a sprayer.
Used thinset and concrete screws to install the backerboard then redguard over the backerboard before tiling.
You could set your tile right on the block if it is flat enough some block work i ve seen has convinced me that the masons were drunk on the job and there is no paint or other coatings that thinset would have a hard time bonding to.
Nail 3 4 expanded metal lath to the blocks with 1 1 2 to 2 inch concrete.
Had to chip off all the thinset with an electric chisel.
There are quite a few ways to prepare a block wall for tile including direct mortar cement board kerdi board and a layer of liquid membrane.
Use a flat scrap of wood to even and smoothen out the surface and let this dry for a few hours or overnight.
Then flush and fill the areas with cement.
Wet a section of the wall again to.
But we had to install 1 2 inch tile backerboard to bring the tile up and over the tub lip.
You should either strip or bead blast the concrete and thoroughly clean it.